Douglas, > -----Original Message----- > From: crossgcc-owner@sourceware.org > On Behalf Of Douglas Coup > Sent: Friday, March 23, 2018 9:01 AM > To: crossgcc@sourceware.org > Subject: secureplt support > > Hi. > > A potential customer has pointed out that the tool chain they use shows this > when they enter "gcc -v": > > Configured with:  ...--enable-secureplt... > > In other words one of the items their tool chain is configured with is the -- > enable-secureplt setting.  Is it possible to enable this setting in a tool chain > produced by Crosstool-NG?  I couldn't find an obvious configuration item for > this in the menus shown by the "ct-ng menuconfig" > command.  The tool chain needs to target 32-bit PowerPC. Yes, actually you can add '--enable-secureplt...' to an option under: 'C compiler -> gcc extra config'. In the .config file this option is: CT_CC_GCC_EXTRA_CONFIG_ARRAY > Regards, > > Douglas Coup Cheers, -Bryan > -- > Objective Systems, Inc. > REAL WORLD ASN.1 AND XML SOLUTIONS > Tel: +1 (484) 875-9841 > Fax: +1 (484) 875-9830 > Toll-free: (877) 307-6855 (USA only) > http://www.obj-sys.com