usertools installation

usertools installation

[Robert Strunce]

I am running windowsNT service pack 4
I down loaded the usertools.exe from one of your suggested sites.
It was down loaded into C:\temp\usertools.exe
It is about 3MB.  I also read the info on installing.
I double clicked on ustertools.exe
it created a folder "pft98~tmp" but it did not give me any information that
is had done so.
I clicked on it a again and noticed that it was infact unpacking some stuff
as noted in a small dialog with a thermaometer bar -- it disapeared without
any info.  Now I have a folder "pft99~tmp".  I tried to delete these
folders and start over but it deleted everything in them but setup.exe
which it will not delete.  

HOW DO I DELETE YOUR SETUP.EXE???
NEXT , DO YOU HAVE INFO ON HOW TO INSTALL AND WHAT TO EXPECT.  THE README
FILES I READ ON THE WEB DID NOT HAVE THE CORRECT INFO AS TO WHAT HAPPENED
TO ME.  
SO WHAT AM I DOING WRONG.

Any help would greately be appreciated.

Regards, Bob Strunce  (703-759-2933)
============================================================================
===
Robert Strunce                      		|| voice: 703-759-2933
Star Technologies Corporation       	|| fax:   703-759-3266
10303 Galpin Court                  	|| cell:  703-629-2933
Great Falls, VA 22066               	|| internet: startech@mindspring.com
USA                                 		||  

--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe@sourceware.cygnus.com