From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (qmail 6723 invoked by alias); 22 Jun 2005 06:48:39 -0000 Mailing-List: contact ecos-discuss-help@ecos.sourceware.org; run by ezmlm Precedence: bulk List-Subscribe: List-Archive: List-Post: List-Help: , Sender: ecos-discuss-owner@ecos.sourceware.org Received: (qmail 6707 invoked by uid 22791); 22 Jun 2005 06:48:31 -0000 Received: from dns.cra.se (HELO cra.se) (212.181.13.155) by sourceware.org (qpsmtpd/0.30-dev) with ESMTP; Wed, 22 Jun 2005 06:48:31 +0000 From: Jokke Ramberg Reply-To: joakim.ramberg@ktc.se To: ecos-discuss@sources.redhat.com In-Reply-To: <20050621192413.g4acl0cmos48g0go@webmail.inf.ufsc.br> References: <20050621192413.g4acl0cmos48g0go@webmail.inf.ufsc.br> Content-Type: text/plain Content-Transfer-Encoding: 7bit Date: Wed, 22 Jun 2005 06:48:00 -0000 Message-Id: <1119422884.3314.12.camel@localhost.localdomain> Mime-Version: 1.0 Subject: Re: [ECOS] MIPS R3000 X-SW-Source: 2005-06/txt/msg00194.txt.bz2 tis 2005-06-21 klockan 19:24 +0000 skrev neuwald@inf.ufsc.br: > Hello all, > > I already installed ecos 2.0 and configtool. Now, I would like to know if there > is instructions specific build an image for MIPS R3000 architecture or make the > porting process. Can anybody help me? > > Regards, > Neuwald > > First go to the CVS, and follow the instructions to make sure you have the latest ecos (the download is apparently not always the most up-to- date). Unless you find the board in the build->templates in the config tool, you have to make a port. In the book "embedded software development with ecos", by A J Massa, which you can download from the ecos site, there is a step-by-step instruction of the start of the porting process. Some of the very initial steps are also described in the ecos ref manual. Then you will probably need a (JTAG-)debugger to test start up and interrupts. Regards Jokke -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss