From mboxrd@z Thu Jan  1 00:00:00 1970
From: Jonathan Larmour <jlarmour@redhat.com>
To: Ling Su <lingsu@palmmicro.com>
Cc: ecos-discuss@sources.redhat.com
Subject: Re: [ECOS] How to access PCI memory(HELP)....
Date: Sun, 10 Sep 2000 19:44:00 -0000
Message-id: <39BC46ED.987DB46B@redhat.com>
References: <003401c019c5$26092880$1201a8c0@crusoe>
X-SW-Source: 2000-09/msg00116.html

> Ling Su wrote:
> 
> I attached my pci1.exe test running result in the end, the UNKNOW device
> is my own card, according to the dump, which address that I should use to
> access the PCI memory? Any helpful explaination will be appreciated very
> much. Thanks a lot in advance!
> 
[snip]
> Found device on bus 0, devfn 0x10:
>  Device configuration succeeded
>  Vendor    0x1688 [UNKNOWN]         <------------ This is my own card
>  Device    0x8888 [UNKNOWN]
>  Command   0x0000, Status 0x0280
>  Class/Rev 0x07800001 [UNKNOWN]
>  Header 0x11FF0E
>  SubVendor 0x1111, Sub ID 0xFF19
>  BAR[0]    0x00410008 / probed size 0xFFFFF008 / CPU addr 0xC0410000
                                                            ^^^^^^^^^^

Looks like this address is where the I/O ports for this card should have
been mapped into the CPU address space. Hopefully my last e-mail provides
some of the explanation. Other than that, UTSL - Use The Source Ling ;)!

Jifl
-- 
Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS  Tel: +44 (1223) 728762
"Plan to be spontaneous tomorrow."  ||  These opinions are all my own fault