Jonathan Larmour wrote:

>
>
> If you just connect with a direct serial connection, when you power on the
> board you should be able to see output like ++$T01.....
>
> If not, then the gdb stub is not programmed onto the board correctly.
>
> Jifl
> --
> Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS  Tel: +44 (1223) 728762
> "Plan to be spontaneous tomorrow."  ||  These opinions are all my own fault

Hi,

this is the output I find when I power on the board (using minicom) under Linux
OS:

.í.cä
ARM Evaluation Board Boot Monitor 1.01 (18 NOV 1999)
Press ENTER within 2 seconds to stop autoboot
Scanning ROM for modules ...
  Found module 'BootStrap' at 04000004
  Found module 'ProductionTest' at 04003a74
  Found module 'Angel' at 0400e7a4
  Found module 'eCos' at 0401ba6c
Boot:

I followed the instruction in "Getting started with eCos", section "ARM AEB-1
Hardware Setup".

I don't see the string you mentioned. In addition, I don't understand the meaning
of the
first sequence of characters.

Have you any idea about the problem?


--
Ing. Andrea Acquaviva
D.E.I.S. - Universita' di Bologna
V.le Risorgimento, 2    40136 BOLOGNA (ITALY)
Tel: (+39) 051 20 93787 Fax: (+39) 051 2093786