Hello,

I cannot start application via redboot's "go" command.
I am in a serious trouble so please help me.

I load application at RAM address 0x8c010000.
After loading RedBoot-bin in ROM using ICE,and loading application in 
RAM,then I set break point at cyg_start.
As I entered "go" command on serial terminal,then next error occured and did 
not stop at cyg_start().

Target board is implemented 16M bytes RAM in area3.
It is difficult to think application program overflows.

-- serial terminal log begin
RedBoot(tm) bootstrap and debug environment [ROM]
Non-certified release, version v3_0 - built 14:47:45, Jan  8 2010

Copyright (C) 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Free Software Foundation, Inc.
RedBoot is free software, covered by the eCos license, derived from the
GNU General Public License. You are welcome to change it and/or distribute
copies of it under certain conditions. Under the license terms, RedBoot's
source code and full license terms must have been made available to you.
Redboot comes with ABSOLUTELY NO WARRANTY.

Platform: lanboard (SH 7705)
RAM: 0x8c000000-0x8d000000 [0x8c004e90-0x8cfed000 available]
FLASH: 0xa0000000-0xa01fffff, 32 x 0x10000 blocks
== Executing boot script in 10.000 seconds - enter ^C to abort
^C
RedBoot> go 0x8c010000
$T0a10:8c010000;0f:8cfecf98;#22

-- serial terminal log end

I checked map file but appeared to me never accessed as high address as 
8cfecf98.
I beseech you to teach me what is wrong.

I send application map file and memory layout files in compressed file.

m mariga