From mboxrd@z Thu Jan 1 00:00:00 1970 From: Gary Thomas To: Fano Ramparany Cc: eCos Disuss Subject: Re: [ECOS] network support Date: Tue, 30 Jan 2001 04:34:00 -0000 Message-id: References: <3A769D9F.927F2CEA@rd.francetelecom.fr> X-SW-Source: 2001-01/msg00467.html On 30-Jan-2001 Fano Ramparany wrote: > I then had a look at the configuration file. > Below is the part of the "ecc" file related the network > drivers. All variables related to the NET_DRIVERS are assigned > a 0 value. > In the (Windows NT) eCos Configuration Tool, the items Initialization > options for 'eth0', are greyed out, and thus can't be > modified. > Do you have any hint about what I'm doing wrong? > This is definitely your problem. Did you create this configuration from scratch? I just tried this, starting fresh, selecting the Cirrus Logic development board + "net" template - AT ONE TIME - and it came out perfectly. Build->Templates->Hardware = Cirrus Logic Development Board Packages = net What sources are you building from? If non anonCVS, then you might consider trying that. Here's an excerpt [from the same point as yours]: # < # Network drivers # cdl_interface CYGHWR_NET_DRIVERS { # Implemented by CYGPKG_DEVS_ETH_ARM_EDB7XXX, active, enabled # This value cannot be modified here. # Flavor: data # Current_value: 1 # The following properties are affected by this value # component CYGPKG_NET_DHCP # ActiveIf: (CYGHWR_NET_DRIVERS > 0) }; # Does the hardware provide an 'eth0' device? # cdl_interface CYGHWR_NET_DRIVER_ETH0 { # Implemented by CYGPKG_DEVS_ETH_ARM_EDB7XXX, active, enabled # This value cannot be modified here. # Flavor: data # Current_value: 1 # The following properties are affected by this value # component CYGHWR_NET_DRIVER_ETH0_SETUP_OPTIONS # ActiveIf: (CYGHWR_NET_DRIVER_ETH0 == 1) };