From mboxrd@z Thu Jan 1 00:00:00 1970 From: Gary Thomas To: Cristiano Ligieri Pereira Cc: ecos-discuss@sourceware.cygnus.com Subject: RE: [ECOS] Port to XScale board Date: Tue, 21 Aug 2001 14:58:00 -0000 Message-id: References: X-SW-Source: 2001-08/msg00723.html On 21-Aug-2001 Cristiano Ligieri Pereira wrote: > >> The binary download won't print any messages. S-record does some >> verification and thus does print things. >> >> First of all, try leaving the "-v" option off. It will only get in >> the way (most recent sources disable it for X-modem). >> >> Then, try loading to some different address - try a much higer one like >> 0x100000. > > RedBoot> load -v -m xmodem > ..Entry point: 0x00060040, address range: 0x00060000-0x00070328 > xyzModem - CRC mode, 1386(SOH)/0(STX)/0(CAN) packets, 4 retries > > RedBoot> dump -b 0x60000 -l 0x100 > 0x00060000: 18F0 9FE5 18F0 9FE5 18F0 9FE5 18F0 9FE5 |................| > 0x00060010: 18F0 9FE5 0000 0000 18F0 9FE5 18F0 9FE5 |................| > 0x00060020: 4000 0600 8801 0600 F001 0600 2802 0600 |@...........(...| > 0x00060030: 8802 0600 0000 0000 7403 0600 3C03 0600 |........t...<...| > 0x00060040: 2106 A0E3 4010 A0E3 0010 80E5 0070 0FE1 |!...@........p..| > 0x00060050: 1F70 07E2 1300 57E3 0700 000A 0000 A0E3 |.p....W.........| > 0x00060060: 1015 9FE5 0420 91E5 0420 80E5 2420 91E5 |..... ... ..$ ..| > > ... > > I found out what was wrong (I put some stupid printf's where i shouldn't > yesterday late night... ). It working fine now. So after downloading the > file I should just type 'go' to the entry point address and it should > work, right? > > That's not happening... :-| (as usual nothing works at the first time...) Try stepping through the code. Time to learn to use GDB :-)