Again: No GUI with ARM AEB-1

["Wilzon L" <ej_leonard@hotmail.com>]

Hello,

I wrote yesterday about my problem getting insight
GUI based gdb to work with ARM-EvBoard AEB-1.

Background:
OS: Red-Hat-Linux 6.1 (Full install)
First I downloaded ecos (ecosSWtools-arm-990321-src.tar.gz)and
extracted and built it successfully.
Finally I extracted the ecos-1.2.1.tar.gz.
I downloaded the GDB-stub onto the AEB-1 and installed
it on the FLASH.
Now if I use $arm-elf-gdb -nw hello (hello.c is in the
examples dir of eCos)
everything works fine, but from now on I would
like to activate the Insight-GUI for GDB.
Ok, so I downloaded insight-20000204.tar.bz2 and
from /tmp/insight-20000204 I invoked ./configure
and then 'make install' which put some binaries
into /usr/local/bin

Here I must say I'm a little bit confused because on my system
there must be 3 different GDB:s. Namely:
1. arm-elf-gdb
2. gdb (v4.18) (native?)
3. gdb (insight with GUI)

Using $/usr/local/bin/gdb with binaries built with
arm-elf-gcc gives some output about not compatible
with i686-pc-linux-gnu.

The 'Getting Started With eCos' chap 13 has a small note
about the '-nw' option saying that without it insight-GUI
would be invoked. Well it doesn't. How could it? The
insight-20000204.tar.bz2 hasn't been built for ARM AEB-1.
So finally my question is: How do I make the Insight-gdb
work with 'ARM AEB-1' ?

Thanks everyone who takes interest in this matter.
Sincerely Wilzon.
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com