From mboxrd@z Thu Jan 1 00:00:00 1970 From: Nicholas_Karagas@cirilium.com To: Chris Faylor Cc: insight@sourceware.cygnus.com Subject: Re: segmentation fault on exit in Insight 5.0 Date: Wed, 28 Jun 2000 13:12:00 -0000 Message-id: X-SW-Source: 2000-q2/msg00346.html >>Hello again, >> >>I tried downloading the gdb/Insight 5.0 release, and still have the same >>problem (SIGSEGV when exiting). Here's the complete backtrace (actually, >>all output) from debugging the Insight session. All I did was start >>Insight with my .gdbinit file and immediately exit. Note that the line >>numbers for remote.c may not match yours exactly, as I have some stuff >>specific to our particular setup in there. I am connecting to a remote >>m68k via Remote/Serial at 38400 baud. I am running Cygwin 1.1.0(0.18/3/2) >>(from uname -r) on WINNT 4.0 (Build 1381: Service Pack 6). Any help on >>this would be greatly appreciated. Thanks. >> >>GNU gdb 4.17.1 > ^^^^^^ >This is not gdb 5.0. > >cgf No, I realize that 4.17.1 is not 5.0. But you must have misunderstood me. I was debugging the Insight/gdb 5.0 cross-debugger for m68k, and to debug it I was using my local gdb, which happens to be 4.17.1. (In other words, the command I entered to get the above output was "gdb m68k-coff-gdb".) The segmentation violation is in Insight 5.0, not gdb 4.17.1. Please take a look at the rest of the output dump if you want to see the problem. I could not show the output from Insight 5.0, because the fault only occurs when I use the GUI. Nicholas Karagas Associate Software Engineer Cirilium Corporation Tempe, AZ (480) 317-1144