* [ECOS] TCP/IP stack does not work when loading via GDB
@ 2001-02-11 23:58 Alex Brown
0 siblings, 0 replies; only message in thread
From: Alex Brown @ 2001-02-11 23:58 UTC (permalink / raw)
To: ecos-discuss
Hi
I have recently ported eCOS to a custom PowerPC based board. The board is
very similar to the MBX, and I used the MBX HAL as a basis for my custom
HAL. (Very minimal changes were required).
I have redboot working, and I can use it to download a RAM based application
that includes networking.
The application runs and the TCP/IP stack appears to be functioning.
However, if I download the same application using GDB via TCP, then
"continue", I get the normal network stack information messages printed out
the diag port, my application runs (LEDs are flashing), but the
quicc_eth_int never gets called.
(The same thing happens if I use GDB via serial).
I am using the anoncvs version as of the 10 Feb 2001 with a patch for static
IP addresses in Redboot.
Another problem I have noticed, is that to get GDB to download via TCP I had
to set the option "set remote X-packet disable", otherwise I would get alot
of "Naks" when attempting the download.
Any help would be greatly appreciated
Regards
Alex Brown
alex@cea.com.au
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2001-02-11 23:58 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2001-02-11 23:58 [ECOS] TCP/IP stack does not work when loading via GDB Alex Brown
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).