RE: [ECOS] peculiar RedBoot network problem

["Trenton D. Adams" <tadams@extremeeng.com>]

  > 
  > "Trenton D. Adams" wrote:
  > >
  > > I run my programs over the network using RedBoot.  RedBoot is set
to
  > use
  > > the ip 172.16.1.240.  My eCos application is set to get an IP
using
  > > DHCP.  It gets an ip of 172.16.1.11.  Now, I ran my eCos program
from
  > > RedBoot, and now a reset of the board does not reset the IP to
  > > 172.16.1.240.  It's almost as if the eCos application has taken
over
  > > some how.  Of course RedBoot doesn't listen on 172.16.1.11 so I
can't
  > do
  > > a GDB connection to there.  Also, running fconfig through a serial
  > port
  > > shows that 172.16.1.240 is in fact the IP RedBoot is setup for.
  > >
  > > Any ideas why this might happen?  I've been running eCos programs
with
  > > network support enabled for the past day using the network GDB of
  > > RedBoot and this hasn't occurred until now.
  > 
  > Have you set a static IP address in your CDL configuration? Or in
your
  > flash configuration?
  > 

My flash configuration for RedBoot is a static IP.  My configuration for
eCos is DHCP.