RE: [ECOS] eCos 1.1 - I need source for Cygmon for Port to new TX39 board.

RE: [ECOS] eCos 1.1 - I need source for Cygmon for Port to new TX39 board.

[Charles Hulcher]

Walter,

Thanks for responding.

I am working with an unusual eval board from Toshiba based on the TX3907.
I'll keep you posted on any info I get.

What processor/board are you interested in?

Regards,
Charles Hulcher

 1/19/99 -0800, you wrote:
>Which board are you planning to port it to, please?  I am also
>interested in porting the MIPS version of eCos.
>	Walter Karshat
>	Project Engineer
>	Hi/fn, Inc.
>	www.hifn.com
>	750 University Ave.
>	Los Gatos, CA 95032
>	(408) 399-3574	(408) 399-3501 fax
>
>> -----Original Message-----
>> From:	Charles Hulcher [SMTP:chulcher@clark.net]
>> Sent:	Tuesday, January 19, 1999 8:23 AM
>> To:	ecos-discuss@cygnus.com
>> Subject:	[ECOS] eCos 1.1 - I need source for Cygmon for Port to
>> new TX39 board. 
>> 
>> I owuld like to port eCos to a different board than the one currently
>> supported. I have found binaries of Cygmon, but no source that would
>> allow
>> me to port it to the new board. I'm assuming that I need Cygmon to use
>> GDB
>> one.
>> 
>> Is the source for Cygmon on the JMR board available so I can modify it
>> for
>> my target? If not, where should I start to get Cygmon source?
>> 
>> Thanks
>> Charles Hulcher
>> chulcher@clark.net
>> chulcher@sterlink.com
>> 
>

[ECOS] eCos 1.1 - I need source for Cygmon for Port to new TX39 board.

[Charles Hulcher]

I owuld like to port eCos to a different board than the one currently
supported. I have found binaries of Cygmon, but no source that would allow
me to port it to the new board. I'm assuming that I need Cygmon to use GDB
one.

Is the source for Cygmon on the JMR board available so I can modify it for
my target? If not, where should I start to get Cygmon source?

Thanks
Charles Hulcher
chulcher@clark.net
chulcher@sterlink.com