* [ECOS] Configuring GDB to use BDM interface to target (custom MPC860 board)
@ 1998-12-30 20:55 Zubin Burjor Sethna
0 siblings, 0 replies; only message in thread
From: Zubin Burjor Sethna @ 1998-12-30 20:55 UTC (permalink / raw)
To: 'ecos discussion mailing list'
Hi gdb'ers
How do I configure and build the gdb debugger that comes with the ecos
software tools to use the BDM debugging hardware of the MPC860. I have a
'wiggler', which is the device used to connect the parallel port to the
target's bdm interface.
Also I had a look at the ppc-bdm.c file in the gdb source directory, it
is setup for the ADS evaluation boards. Our hardware is custom made so I
need to remove any code that is specific to this board. Apart from
removing unnecessary calls to ocd_write_bytes(), do I need to do
anything else?
Much Thanks
Zubin
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~1998-12-30 20:55 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
1998-12-30 20:55 [ECOS] Configuring GDB to use BDM interface to target (custom MPC860 board) Zubin Burjor Sethna
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).