Query

Query

[Robin Dua]

[-- Attachment #1: Type: text/plain, Size: 847 bytes --]


hi,

I am Robin Dua. I am doing the testing of USB device controller on ARM 
Integrator/AP board using eCos.

The question is that the eCos Ver.1.3.1 manual (getting started with 
eCos) provides eCos ROM image downloads to Flash for ARM PID board and 
not for Integrator board.Since on page 45 of the manual there is a 
referring to 

1. Set jumper 7-8 on LK6 [using the Angel code in the 16 bit EPROM]
2. Set jumper 5-6 on LK6 [select 8bit ROM mode]
3. Set jumper LK18 [ROM remap - this is also required for eCos]
4. Set S1 to 0-0-1-1 [20MHz operation]
5. Open jumper LK4 [enable little-endian operation]

now i read the ARM Integrator /AP manual USER Guide and there is no 
mention of what is LK6.

Please solve my problem as to how should i set these jumpers except for 
S1.Please also mention what is Angel code.

warm regards,

Robin Dua
 


[-- Attachment #2: Wipro_Disclaimer.txt --]
[-- Type: text/plain, Size: 522 bytes --]

**************************Disclaimer**************************************************    
 
 Information contained in this E-MAIL being proprietary to Wipro Limited is 'privileged' 
and 'confidential' and intended for use only by the individual or entity to which it is 
addressed. You are notified that any use, copying or dissemination of the information 
contained in the E-MAIL in any manner whatsoever is strictly prohibited.

****************************************************************************************